Chama Engine House Lathe and Mill
| August 28, 2016 03:35AM |
|
Howdy Folks,
I was wondering if anyone out there would have any info on the make/model of the Chama engine house lathe and mill? If we knew who made it we could find drawings/measurements to make models of this stuff.
Thanx in advance for any help!
Dan
I was wondering if anyone out there would have any info on the make/model of the Chama engine house lathe and mill? If we knew who made it we could find drawings/measurements to make models of this stuff.
Thanx in advance for any help!
Dan
| Subject | Author | Posted |
|---|---|---|
|
bookemdanno | August 28, 2016 03:35AM |
|
OLCO107 | August 28, 2016 05:46AM |
|
vince heying | August 28, 2016 09:25AM |
|
John Cole | August 28, 2016 09:36AM |
|
bookemdanno | August 30, 2016 04:43AM |
|
davegrandt | August 30, 2016 12:34PM |
|
Paul-NC | August 31, 2016 02:03PM |
|
Dick Bell | August 31, 2016 04:01PM |
|
bookemdanno | August 31, 2016 04:28PM |
|
Dick Cowles | August 31, 2016 07:12PM |
|
Bill Pratt | August 31, 2016 07:54PM |
|
GeorgeGaskill | September 02, 2016 07:49PM |
Sorry, only registered users may post in this forum.
488 stops for water at Los Pinos tank on closing day Oct. 1979. Photo courtesy Don Richter
The NGDF was started by Don Richter and is currently operated in his memory by Nathan Holmes and others. Others who have contributed to the upkeep of this board are (in no particular order): Charles McCandless, Everett Lueck, Ted Wilton, Cole Adams, James Bane, John Moellmer, Jon Bentz, Linn Moedinger, lloyd lehrer, Rod Jensen, John Craft, Steven Forney, Herb Kelsey, Bill Ramaley, Russ Sperry (El Russo Loco), Josh McNeal, John West, Jim Armstrong, Bob Bergstrom, Greg Scholl, Blake Forbes Doug van Veelen and Mark Fuller.