Welcome! Log In Create A New Profile

Re: Chama Engine House Lathe and Mill

Previous Message Next Message

Forum List Message List New Topic Print View

Dick Bell

August 31, 2016 04:01PM

Registered: 16 years ago
Posts: 1,012

parts on 6200 Chama 10-87

Reply Quote

Message List Previous Message Next Message

RSS

Subject	Author	Posted
Chama Engine House Lathe and Mill	bookemdanno	August 28, 2016 03:35AM
Re: Chama Engine House Lathe and Mill	OLCO107	August 28, 2016 05:46AM
Re: Chama Engine House Lathe and Mill	vince heying	August 28, 2016 09:25AM
Re: Chama Engine House Lathe and Mill	John Cole	August 28, 2016 09:36AM
Re: Chama Engine House Lathe and Mill	bookemdanno	August 30, 2016 04:43AM
Re: Chama Engine House Lathe and Mill	davegrandt	August 30, 2016 12:34PM
Re: Chama Engine House Lathe and Mill	Paul-NC	August 31, 2016 02:03PM
Re: Chama Engine House Lathe and Mill	Dick Bell	August 31, 2016 04:01PM
Re: Chama Engine House Lathe and Mill	bookemdanno	August 31, 2016 04:28PM
Wheel Lathe Purchased by RGRPC in Spring 2000.	Dick Cowles	August 31, 2016 07:12PM
Re: Chama Engine House Lathe and Mill	Bill Pratt	August 31, 2016 07:54PM
Re: Chama Engine House Lathe and Mill	GeorgeGaskill	September 02, 2016 07:49PM

Sorry, only registered users may post in this forum.

Click here to login

488 stops for water at Los Pinos tank on closing day Oct. 1979. Photo courtesy Don Richter

The NGDF was started by Don Richter and is currently operated in his memory by Nathan Holmes and others. Others who have contributed to the upkeep of this board are (in no particular order): Charles McCandless, Everett Lueck, Ted Wilton, Cole Adams, James Bane, John Moellmer, Jon Bentz, Linn Moedinger, lloyd lehrer, Rod Jensen, John Craft, Steven Forney, Herb Kelsey, Bill Ramaley, Russ Sperry (El Russo Loco), Josh McNeal, John West, Jim Armstrong, Bob Bergstrom, Greg Scholl, Blake Forbes Doug van Veelen and Mark Fuller.