Welcome! Log In Create A New Profile

Re: Scratchbuilding HOn3 or On3 chassis.

Forum List Message List New Topic Print View

MSRRKevin

September 22, 2020 03:06PM

Registered: 14 years ago
Posts: 272

What do you want to make it out of? I 3d printed a 4-6-0 frame based on the old MDC/Roundhouse design using a nylon type plastic. I also printed a gearbox that uses gears I bought as an assortment off of Amazon. Siderods were 3d printed in wax, and then cast in brass. All was done thru Shapeways. It functions as well as the MDC frame, and was not that hard to draw.

Reply Quote

Message List Previous Message Next Message

RSS

Subject	Author	Posted
Scratchbuilding HOn3 or On3 chassis.	I_love_D&RG	September 22, 2020 09:57AM
Re: Scratchbuilding HOn3 or On3 chassis.	Glenn Butcher	September 22, 2020 11:19AM
Re: Scratchbuilding HOn3 or On3 chassis.	Glenn Butcher	September 22, 2020 01:49PM
Re: Scratchbuilding HOn3 or On3 chassis.	MSRRKevin	September 22, 2020 03:06PM
Re: Scratchbuilding HOn3 or On3 chassis.	I_love_D&RG	September 22, 2020 03:15PM
Re: Scratchbuilding HOn3 or On3 chassis.	Casey Akin	September 22, 2020 09:31PM

Sorry, only registered users may post in this forum.

Click here to login

488 stops for water at Los Pinos tank on closing day Oct. 1979. Photo courtesy Don Richter

The NGDF was started by Don Richter and is currently operated in his memory by Nathan Holmes and others. Others who have contributed to the upkeep of this board are (in no particular order): Charles McCandless, Everett Lueck, Ted Wilton, Cole Adams, James Bane, John Moellmer, Jon Bentz, Linn Moedinger, lloyd lehrer, Rod Jensen, John Craft, Steven Forney, Herb Kelsey, Bill Ramaley, Russ Sperry (El Russo Loco), Josh McNeal, John West, Jim Armstrong, Bob Bergstrom, Greg Scholl, Blake Forbes Doug van Veelen and Mark Fuller.