Welcome! Log In Create A New Profile

Re: DRG 168 Cylinder Work

Forum List Message List New Topic Print View

Rick Rowlands

December 09, 2017 04:05PM

Registered: 9 years ago
Posts: 101

Great photos! I do have a question though. After boring out the cylinders, what is done about the increased clearance between the diameter of the piston and the diameter of the cylinder? At what point does the clearance become too great? Is there a standard tolerance based on cylinder diameter?

Reply Quote

Message List Previous Message Next Message

RSS

Subject	Author	Posted
DRG 168 Cylinder Work	porterno2	December 09, 2017 10:41AM
Re: DRG 168 Cylinder Work	Rick Rowlands	December 09, 2017 04:05PM
Re: DRG 168 Cylinder Work	davidtltc	December 09, 2017 05:50PM
Re: DRG 168 Cylinder Work	porterno2	December 09, 2017 06:18PM
Re: DRG 168 Cylinder Work	rehunn	December 09, 2017 07:30PM

Sorry, only registered users may post in this forum.

Click here to login

488 stops for water at Los Pinos tank on closing day Oct. 1979. Photo courtesy Don Richter

The NGDF was started by Don Richter and is currently operated in his memory by Nathan Holmes and others. Others who have contributed to the upkeep of this board are (in no particular order): Charles McCandless, Everett Lueck, Ted Wilton, Cole Adams, James Bane, John Moellmer, Jon Bentz, Linn Moedinger, lloyd lehrer, Rod Jensen, John Craft, Steven Forney, Herb Kelsey, Bill Ramaley, Russ Sperry (El Russo Loco), Josh McNeal, John West, Jim Armstrong, Bob Bergstrom, Greg Scholl, Blake Forbes Doug van Veelen and Mark Fuller.