Re: C-16 design question, revisting an old thread

today it should be set up same as the c-19s. there is the A spring on the pony, then a wishbone that connects with the B spring over the #1 driver. The B spring should have a hanger going down to an equalizer between it and the C spring. The equalizer is on the bottom frame rail. The C spring also has a hanger connected to the equalizer, while the other end of the C spring has a hanger connected to the top frame rail. The D spring between the #3, and #4 has an equalizer on both sides of it. one over the #3 and one over #4. At the end of the equalizer there is a rod hanging down that goes through the lower frame rail with a coil spring and a nut to keep it there, and for adjustment.

this is if its the same as a c-19.