Welcome! Log In Create A New Profile

poling pockets

Forum List Message List New Topic Print View

Doc

November 04, 2014 10:18AM

Registered: 14 years ago
Posts: 193

Good morning gentlemen: I am in need of dimensions of poling pockets from a shay locomotive. Did they use a single size casting on all of their engines, are where there different sizes. Optimally I require the three dimension of the base plate, the pocket and the angle of the pocket cut. Ant the size of the square hole in the center. Thank you. Doc

Reply Quote

Message List Previous Message Next Message

RSS

Subject	Author	Posted
poling pockets	Doc	November 04, 2014 10:18AM

Sorry, only registered users may post in this forum.

Click here to login

488 stops for water at Los Pinos tank on closing day Oct. 1979. Photo courtesy Don Richter

The NGDF was started by Don Richter and is currently operated in his memory by Nathan Holmes and others. Others who have contributed to the upkeep of this board are (in no particular order): Charles McCandless, Everett Lueck, Ted Wilton, Cole Adams, James Bane, John Moellmer, Jon Bentz, Linn Moedinger, lloyd lehrer, Rod Jensen, John Craft, Steven Forney, Herb Kelsey, Bill Ramaley, Russ Sperry (El Russo Loco), Josh McNeal, John West, Jim Armstrong, Bob Bergstrom, Greg Scholl, Blake Forbes Doug van Veelen and Mark Fuller.