Welcome! Log In Create A New Profile

Advanced

Re: Yes NG: Turntable too short? Just Weld on a Bit!

April 15, 2017 12:53PM avatar
I haven't seen anything mentioned about it yet as being a true Sellers, these were used down here but the Sellers was a very close visually to the NZR own produced cast tables and the Lloyds Forster turntables produced in Great Britian. From what I gather the Sellers had raised rings around the holes in the side plates which the Glenbrook version doesn't have.

link to the installation of table [www.gvr.co.nz]
and a close-up of the Glenbrook table.
[www.gvr.co.nz]

Cheers from Under

Chris
in New Zealand
Subject Author Posted

NNG: Turntable too short?

Chris Webster April 13, 2017 06:48PM

Re: NNG: Turntable too short?

bcp April 13, 2017 06:54PM

Re: NNG: Turntable too short?

Chris Walker April 13, 2017 11:32PM

Re: Yes NG: Turntable too short? Just Weld on a Bit! Attachments

Chris Walker April 13, 2017 11:43PM

Re: Yes NG: Turntable too short? Just Weld on a Bit!

nedsn3 April 15, 2017 11:41AM

Re: Yes NG: Turntable too short? Just Weld on a Bit!

Chris Walker April 15, 2017 12:53PM

Re: Yes NG: Turntable too short? Just Weld on a Bit!

Jim McKee April 16, 2017 05:43PM

Re: Yes NG: Turntable too short? Just Weld on a Bit!

Chris Walker April 16, 2017 08:27PM

Re: NNG: Turntable too short?

bcp April 14, 2017 08:23AM

Re: NNG: Turntable too short?

wishiwasincolorado April 14, 2017 01:28PM

Re: NNG: Turntable too short?

Bruce R. Pier April 14, 2017 03:07PM

Re: NNG: Turntable too short?

Stan Fischer April 14, 2017 03:49PM

Re: NNG: Turntable too short?

Casey Akin April 14, 2017 09:22PM



Sorry, only registered users may post in this forum.

Click here to login